TM 9-4310-397-14
4-42. RELAY RESET SWITCH TESTING AND REPLACEMENT.
This task covers:
a.
Removal
b.
Testing
c.
Installation
INITIAL SETUP
Tools:
Equipment Conditions:
General Mechanics Tool Kit
Control panel door open.
Item 1, Section III, Appendix B
Battery cables disconnected from batteries. (See para
Shop Equipment Electrical
4-49.)
Item 3, Section III, Appendix B
a.
Removal.
NOTE
Terminal and mounting hardware is supplied with most components and cannot be purchased
separately. Retain all hardware if original component is not being replaced. If component is being
replaced, use new hardware supplied.
(1)
Tag (item 18, section II, appendix E) wire leads (Figure 4-39, 2).
(2)
Remove terminal screws (1).
(3)
Disconnect wire leads (2) from RESET RELAY switch (3).
Figure 4-39. Relay Reset Switch
(4)
Remove hex nut (4), lock washer (5), flat washer (6), and RESET RELAY switch (3).
(5)
Remove fuse (7) from the bottom of the RESET RELAY switch (3) terminal ends.
4-111