TM 9-4310-397-14
4-39. ENGINE OIL PRESSURE GAUGE TESTING AND REPLACEMENT . - Continued
b.
Installation.
NOTE
Mounting hardware is supplied with most components and cannot be purchased separately.
Retain all hardware if original component is not being replaced. If component is being replaced,
use new hardware supplied.
(1)
Install ENGINE OIL PRESSURE gauge (Figure 4-36, 8) onto front of control panel.
(2)
Install two each hex nuts (5), lock washers (6), bracket (7), and tighten.
(3)
Wrap antiseize tape (item 1, section II, appendix E) onto threads of male connector (2), bushing reducer
(3) and ENGINE OIL PRESSURE gauge (8).
(4)
Install pipe coupling (4), bushing reducer (3), and male connector (2).
(5)
Connect hose (1) to male connector (2).
(6)
Check for leaks after unit is started.
(7)
Close roadside and control panel doors.
4-106
