TM 9-4310-397-14
4-41. IGNITION SWITCH TESTING AND REPLACEMENT .
This task covers:
a.
Removal
b.
Testing
c.
Installation
INITIAL SETUP
Tools:
Equipment Conditions:
General Mechanics Tool Kit
Control panel door open.
Item 1, Section III, Appendix B
Battery cables disconnected from batteries.
(See para 4-49.)
a.
Removal.
NOTE
Terminal and mounting hardware is supplied with most components and cannot be purchased
separately. Retain all hardware if original component is not being replaced. If component is being
replaced, use new hardware supplied.
(1)
Remove terminal screws (Figure 4-38, 1).
(2)
Tag (item 18, section II, appendix E) and disconnect wire leads (2).
Figure 4-38. Ignition Switch
(2)
Unscrew knob (3) and remove.
(3)
Remove hex nut (4), lock washer (5), and IGNITION SWITCH (6).
4-109