TM 9-4310-397-14
4-46. RECEIVER PRESSURE GAUGE REPLACEMENT.
This task covers:
a.
Removal
b.
Installation
INITIAL SETUP
Tools:
Equipment Conditions:
General Mechanics Tool Kit
Control panel door open.
Item 1, Section III, Appendix B
Battery cables disconnected from batteries. (See para
4-49.)
a.
Removal.
NOTE
Terminal mounting hardware is supplied with most components and cannot be purchased
separately. Retain all hardware if original component is not being replaced. If component is being
replaced, use new hardware supplied.
(1)
Remove terminal screws (Figure 4-43, 1) and tag (item 18, section II, appendix E) and disconnect and wire
leads (2).
Figure 4-43. Receiver Pressure Gauge
(2)
Remove pressure switch (3) from pipe tee (4).
(3)
Disconnect hose (5) from elbow (6).
(4)
Remove elbow (6) from pipe tee (4).
4-119
