TM 9-4310-397-14
4-47. HOSE REEL REPLACEMENT. - Continued
(3)
Reel Assembly.
(a)
Remove valve (8), elbow (9), and pipe nipple (10). Disassemble if required.
(b)
Remove six hex head bolts (11), flat washers (12), and self locking nuts (13). Discard self locking nuts.
(c)
Remove hose reel ends (14) and (15) from hose reel body (16).
(d)
Remove grease fitting (17) from hose reel body (16).
(e)
Remove trim (18) and (19) from hose reel ends (14) and (15) if it is damaged and needs replacement.
b. Installation.
(1)
Reel Assembly.
(a)
Wrap antiseize tape (item 1, section II, appendix E) around the grease fitting threads (17) and install onto
hose reel body (16).
(b)
Assemble hose reel body (16) and two hose reel ends (14) and (15). Secure with six hex head bolts (11),
flat washers (12), and new self locking nuts (13) (item 5, appendix H).
(c)
Wrap antiseize tape (item 1, section II, appendix E) around the pipe nipple threads (10) and install into
hose reel body (16).
(d)
Wrap antiseize tape (item 1, section II, appendix E) around the threaded elbow end (9) and coupling (1).
(e)
Assemble valve (12), elbow (9), and coupling (1) and install as an assembly.
(f)
Fabricate trim in accordance with appendix F, Figure F2.
(g)
Install trim (18) and (19) onto outside edge of hose ends (14) and (15) using adhesive (item 5, section II,
appendix E).
(2)
Hose Assembly.
(a)
Fabricate new hose in accordance with appendix F, Figure Fl, part number 62400/hose.
(b)
Install hose (7), air hose clamps (5), coupling (2), and secure hex screws.
(c)
Install the opposite end of hose (7), air hose clamp (5), coupling (6), and secure with hex nuts (3) and
square head screws (4).
(d)
Mate couplings (1) and (2) by twisting until they interlock in place.
(e)
Rewind hose onto reel. Be sure that hose does not kink.
(f)
Close curbside doors.
4-122
