TM 9-4310-397-14
4-48. MISCELLANEOUS WIRES AND CABLES TESTING AND REPLACEMENT. - Continued
c.
Repair.
(1)
Cable.
(a)
See appendix F (89886-1/1) for cable fabrication.
(b)
Cut cable to size required.
(c)
Strip 1/2 inch (1.3 cm) of insulation from the ends of the cable.
(d)
Install terminals (10) and (11) on the ends of the cable.
(e)
Crimp the terminal shanks.
(2)
Wire.
(a)
See appendix F (89892-1/6) for wire fabrication.
(b)
Cut wire (9) to size required.
(c)
Strip 3/8 inch (0.97 cm) of insulation from the end of the wire.
(d)
Install loom (14). See appendix F (89892-1/4) for loom fabrication. Secure loom with two electrical
tiedown straps (15).
(e)
Install terminals (12) and (13) on the ends of wire.
(f)
Crimp the terminal shanks.
(g)
Install wire markers (16) on each end of wire. Wire number is 27.
d.
Installation.
(1)
Install cable (6), hex head screw (1), and new lock washer (2) (item 14, appendix H).
(2)
Install hex head screw (3), two flat washers (4), and new self locking nut (5) (item 20, appendix H).
(3)
Install wire (9) and secure with pan head screws (7) and nut (8).
(4)
Connect battery cables to batteries. See paragraph 4-49.
4 -124
