TM 9-4310-397-14
4-50. RADIATOR HOSE AND OIL LINES REPLACEMENT. - Continued
(2) Remove hex head screw (3), spacer (4), and hose clamp (5).
(3) Loosen hose clamps (6) and pull lower engine coolant hose (7).
NOTE
Do not remove (drill out) rivnut unless it is damaged.
(4) Remove pan head screw (8), clamps (9) and (10), and rivnut (11).
(5) Loosen hoses (12) and (13) and remove.
(6) Remove elbows (14) and adapters (15).
(7) Remove hose (16).
b.
Installation.
(1) Install lower radiator hose (7) and hose clamps (6).
(2) Install clamp (5), spacer (4), and hex head screw (3).
(3) Install upper radiator hose (2) and hose clamps (1).
(4) Wrap antiseize tape (item 1, section II, appendix E) on threaded end of elbows (14) and adapter (15).
(5) Install elbows (14) and adapters (15).
(6) Connect hoses (12), (13), and (16).
(7) Install clamps (9) and (10) with pan head screw (8) and new rivnut (11) if removed.
(8) Refill engine coolant. See paragraph 4-6, e.
(9) Refill compressor oil. See paragraph 4-6, d (2).
(10) Connect battery cables to batteries. See paragraph 4-49.
(11) Close curbside door.
4 -130
