TM 9-4310-397-14
4-51. RADIATOR REPLACEMENT. -Continued
(3) Remove six hex head screws (5), lock washers (6), and flat washers (7) from radiator (2). Discard lock washers.
(4) Carefully lift radiator (2) up and out of unit.
NOTES
Remove gaskets only if replacement is required.
(5) Remove gaskets (8) by scraping off.
b.
Installation.
(1) Fabricate gaskets (8) per the following:
(a)
Cut gasket per appendix F.
(b)
Scrap off any gasket material left on radiator (2).
(c)
Apply adhesive (item 11, section II, appendix E) to one side of gaskets and radiator.
(d)
Air dry until tacky but will not stick to fingers.
(e)
Press gaskets firmly into place.
(2)
Carefully lift radiator (2) into place and aline with opening for drain cock and mounting holes.
(3)
Use six hex head screws (5), new lock washers (6) (item 14, appendix H), flat washers (7), and tighten into
radiator (2)
(4)
Wrap antiseize tape (item 1, section II, appendix E) on threaded end of drain cock (1) and pipe nipple (4).
(5)
Install pipe nipple (4), coupling (3), and drain cock (1) into radiator.
(6)
Install fuel tank per paragraph 4-56.
(7)
Install radiator hoses and oil cooler hoses per paragraph 4-50.
(8)
Install rear panel per paragraph 4-31, d,(2).
(9)
Refill engine coolant per paragraph 4-6, e and compressor oil per paragraph 4-6, d,(2).
(10) Connect battery cables to batteries per paragraph 4-49.
4 -132