TM 9-4310-397-14(4)Support starter (9) while removing two hex head screws (10), and lock washers (11). Discard lockwashers.(5)Carefully pull starter away from engine.b.Testing.(1)Testsetup.(a)Starter removed, battery, ammeter, momentary switch, voltmeter, RPM indicator, wire leads andcarbon pile are required to perform test.WARNINGHigh current surges can occur while connecting or disconnecting wire leads, causingpersonal injury to personnel. Insure switch is in the open position.NOTECarbon pile load is used to adjust operating voltage for comparison with specifications.(b) Setup equipment as shown in (Figure 4-74).Figure 4-74. Starter No Load Test Hook Up4-171
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
