TM 9-4310-397-14
(3)
Install fuel line (2) and clamp (1).
(4)
Fill fuel tank.
(5)
Bleed fuel system per the following:
(a) Loosen vent plug (Figure 4-78, 1) on fuel filter.
Figure 4-78. Fuel Bleed Procedure
WARNING
Diesel fuel escaping under pressure can have sufficient force to penetrate the skin causing
serious personal injury. Infection or reaction can develop if medical treatment is not
administrated immediately.
NOTE
Wiping rags can be used to soak up fuel that seeps from filter during bleeding procedure.
(b)
Operate primer lever on fuel pump until fuel flow is free of air bubbles.
(c)
Tighten vent plug (1).
(d)
Start engine. If engine does not start proceed to next step.
(e)
Place throttle lever in fast idle position.
(f)
Use two open end wrenches, and loosen all three fuel lines (3) at injection nozzles.
(g)
Turn over engine with starter motor until fuel flows free from bubbles at loosened connections.
(h)
Torque connections to 18 ft lb (25 Nm).
(6)
Close roadside and curbside doors.
4-177