TM 5-4310-393-14a.Disconnect the inlet and outlet tubes fromthe filter head using a n open end wrench.b.Unscrew threaded collar (1). Removefilter head (2) and sintered filter assembly (3). Removethe center screw (4) to remove the filter element (5).Inspect O-ring (6) for damage. Replace if necessary.2.Cleaning the Sintered Filter (5).a Clean the element using hot soapywater. Blow dry with compressed air.3.Reassembling the Intermediate Filter.a.Coat the threads and O-ring and thethreads of the filter element with a thin coat of halocarbon grease.b.Dry the inside of the filter housing with aclean cloth and check for corrosion before reinstallingthe filter element. If excessive corrosion is found, referto Unit Maintenance.FIGURE 3-12. INTERMEDIATE FILTER3-15. DIESEL ENGINE.This task covers' A Inspect B. ServiceTools:Materials/PartsTool kit, General Mechanic's SetOilCloth, Lint-free NSN 7920-00-044-9281Copper Gasket PIN 50001500Equipment Conditions:Engine Shut Down After RunningA.INTRODUCTION. This paragraph covers maintenance procedures at the operator level for the diesel engine.3-21
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
