TM 3-4310-100-20 & P
Figure 2-1. Compressor Alteration Parts (charging hose assembly).
f.
a. Remove and discard the existing adapter
Remove rubber case from pressure gage.
located on top of the water separator.
b. Install preformed packing NSN 5330-00-805-
tighten
g. Install rubber case on gage.
c. Install elbow on top of water separator.
h. Apply one wrapping of antiseize tape to threads
Position elbow so it points toward the fuel tank. Tighten
on both ends of adapter NSN 4730-00--618-3410.
i.
Screw adapter into tee and tighten.
lock nut.
d. Apply one wrapping of antiseize tape, NSN
j.
Screw hose assembly, NSN 4720-00-2i89 to
8030-00-899-3535, on elbow threads.
the adapter.
k. Install valve assembly, NSN 1040-00-759-7352
until it bottoms. Loosen tee until side hole faces away
on the hose assembly.
l.
from fuel tank.
valve assembly.
m. Install coupling half, quick-disconnect, NSN
NOTE
4720-00-863-0774 on adapter.
On
AN-M4
move
n. Coil and tie hose to frame with starting rope.
instruction plate away from water
separator to allow installation of
pressure gage.
2-2