TM 5-4220-233-14
Figure 4-2. Electrical Schematic.
(3) Connect wires of cable to five fusible links (4) and terminal board (5) as shown on electrical schematic
placard (See Figure 4-42).
(4) Refer to Figure 4-41 and insert packing assembly(9) into stuffing tube body (7) thread cap (6) onto body
(5) Adjust position of cable (8) so that connections in electrical box (1) are not stressed.
(6) Tighten cap (6) on body hand tight. Then, tighten cap an additional 1/2 turn.
(7) Spray a coat of electrical varnish (Item 18, Appendix D) on connections between cable, five fusible links
(4),
and terminal board (5).
(8) Close lid on electrical box (1) and secure by sliding four clips (3) over edge of lid and tightening four screws
(2).
c.
Intervehicular Cable Repair. Refer to the appropriate guidelines for general instructions on electrical
repairs.
4-84
