Figure 33. Starter repair.

Figure 33. Starter repair.

and the commutator end frame assem-

between the leads of the connector and

bly. If the lamp lights, the brush

their respective pin sockets. Failure

holder is grounded and the commu-

of the lamp to light indicates an open

tator end frame assembly must be re-

circuit and the defective electrical re-

placed. Test between the grounded

ceptacle connector must be replaced.

brush holder and commutator end

Test between the leads of the electrical

frame. If the lamp fails to light, the

receptacle connector. If the test lamp

lights, a short exists and the connector

brush holder is defective and the com-

must be replaced. Test between each

mutator end frame assembly must be

replaced.

lead and the body of the electrical re-

ceptacle connector. If the lamp lights,

c. Reassembly and Installation.

a grounded condition exists and the

(1) Refer in figure 32 and reassemble the

connector must be replaced.

(17) Test the commutator end frame as-

(2) Refer to paragraph 64 and install the

sembly with a test lamp circuit. Test

between the insulated brush holder

AGO 8166A