TM 5-4310-277-14
(2) Remove all tie-downs or blocking that
pressor, Models HGR5-8M-1 and HGR5-8M-6, to
secure the crated air receiver mounted air com-
the carrier. Refer to figure 4-2.
mounted air compressor, Models HGR5-8M-1 and
HGR5-8M-6, from the carrier
Make certain any lifting device used has a
capacity equal to the weight being lifted.
b. If some units and components are packaged or
Failure to observe this precaution could
crated, proceed as follows to remove packaging or
result in injury or death to personnel and
crate, whichever applies.
damage to the equipment.
(1) Models BGR-5M-1, and HGR5-8M-6.
(3) The trailer mounted air compressor, Model
BGR-5M1, may be towed off the carrier if a suitable
close to the point where it is to be used as possible.
ramp is provided, or lifted off with a hoist or crane
(b) Remove the canvas protective cover.
by attaching suitable slings to the lifting eyes on the
(c) Remove the box containing the air hose
trailer. A forklift truck, pipe rollers, or a suitable
assembly, inflator gage, and starter rope. These are
hoist must be used when removing the air receiver
shown in Figure 4-3.
Change 1
