TM 5-4310-277-14
mar the instruction plate attached to the side of tool
b. Cleaning and Inspection.
box.
(2) Inspect the interior and exterior of the box
Dry cleaning solvent, P-D-680, used to clean
for cracks, dents, corrosion, and other damage.
parts is potentially dangerous to personnel
Inspect padlock for malfunction and padlock chain
and property. Avoid repeated and
for broken links. Check all attaching parts for
prolonged skin contact. Do not use near
damaged threads.
open flame or excessive heat. Flash point of
solvent is 100 F. (38oC. ) - 138o F. (59 C.).
(3) Replace any defective parts.
c. Installation. Install the tool box as shown in
(1) Clean the tool box thoroughly inside and out
with cleaning solvent, Federal Specification P-D-
680, and dry thoroughly. Be careful not to damage or
Section X. MAINTENANCE OF DRIVE PULLEY, BELT GUARD, AND BELT SET
(3) Remove the belt guard as illustrated in
a. Removal.
(1) Stop the engine.
Do not operate the air compressor with the
(2) Release the air from the compressor by
belt guard off.
opening the draincock.
