TM 5-4310-277-14
b. Cleaning and Inspection.
Federal Specification P-D-680, and dry thoroughly.
Use a wire brush on the muffler to remove any rust
Dry cleaning solvent, P-D-680, used to clean
or corrosion that may have accumulated.
parts is potentially dangerous to personnel
(2) Inspect the muffler and attaching parts for
and property. Avoid repeated and
cracks, breaks, damaged threads or other defects.
prolonged skin contact. Do not use near
(3) Replace a defective part.
open flame or excessive heat. Flash point of
c. Installation. Install the engine muffler as
solvent is 100 F. (38oC.) - 138 F. (59 C.).
shown in figure 4-12.
(1) Clean all parts with cleaning solvent,
Section IX. MAINTENANCE OF TOOL BOX, MODEL BGR-5M-1
a. Removal. Remove the tool box as shown in
