TM 5-4310-277-14
(3) Replace damaged or defective parts.
b. Cleaning and Inspection.
c. Installation. Install the belt guard as illustrated
in figure 4-14.
Dry cleaning solvent, P-D-680, used to clean
parts is potentially dangerous to personnel
4-19. V-Belts
and property. Avoid repeated and
a. Removal.
prolonged skin contact. Do not use near
(1) Stop the engine.
open flame or excessive heat. Flash point of
(2) Release the air from the compressor by
solvent is 100 F. (38oC.) - 138 F. (59 C.).
opening the draincock.
(1) Clean the parts in cleaning solvent, Federal
(3) Remove the belt guard.
Specification P-D-680, and dry thoroughly.
(4) Remove the V-belts as illustrated in figure 4-
(2) Inspect the belt guard and mounting
brackets for dents, cracks, breaks or other damage.
Straighten minor dents and bends in the guard and
brackets. Inspect all attaching hardware for
damaged threads.
