TM 5-4310-354-14
d. Stopping the Equipment.
(2) Perform the necessary after operation
preventive maintenance checks and
(1) Refer to figure 2-7 and stop the air
services (table 3-1).
compressor unit.
TS5-4310-354-14/2-7
STEP 1
CLOSE ALL DISCHARGE SERVICE
NOTE
VALVES (FIG 2-5). DISCONNECT AND
STOW PNEUMATIC TOOLS THAT WERE
THIS UNIT IS EQUIPPED WITH
BEING USED FOR THE JOB.
SAFETY DEVICES (FIG 2-4) WHICH
AUTOMATICALLY STOP THE ENGINE
STEP 2.
ALLOW UNIT TO RUN UNLOADED FOR
DUE TO :
HIGH TEMPERATURE
FIVE MINUTES.
COMPRESSOR
OIL,
HIGH
TEMPERATURE ENGINE COOLANT,
STEP 3.
SWITCH THE PANEL LAMP SWITCH TO
LOW ENGINE OIL PRESSURE, AND
OFF.
ENGINE OVERSPEED.
IF ENGINE
STOPS DURING OPERATION FOR
STEP 4.
PUSH IGNITION SWITCH IN TO OFF
ONE
OF
THESE
REASONS,
POSITION
DETERMINE CAUSE OR REPORT
CONDITION TO ORGANIZATIONAL
MAINTENANCE
BEFORE
ATTEMPTING TO START AGAIN. ALL
SAFETY DEVICES ARE AUTOMATIC
RESET,
EXCEPT
ENGINE
OVERSPEED WHICH IS MANUAL.
Figure 2-7. Air compressor unit stopping procedure.
2-14
