TM 5-4310-354-14
STEP 1
WIPE ARM,
PIVOT POINTS, CONTROL
ROD AND
SPRING WITH A CLOTH
MOISTENED
WITH SOLVENT, FED SPEC
P-D-680, OR
EQUIVALENT. THEN, WIPE
DRY.
STEP 2.
USING AN OI L CAN, APPLY 3 TO 5
DROPS OF ENGINE OIL TO ALL PIVOT
POINTS AND SPRING.
NOTE
REFER TO L05-4310-354-12, FIG 3-1,
FOR LUBRICANTS.
TS5-4310-354-14/4-1
Figure 4-1. Speed control linkage lubrication.
(3) Lubricate the quick start assembly as
shown in figure 4-2.
STEP 1.
REMOVE THE FUEL CYLINDER (FIG
DROPS OF ENGINE OIL ON EXPOSED
PORTION OF MECHANICAL VALVE
SHAFT.
STEP 2.
WIPE ACTUATING CABLE WITH A CLOTH
MOISTENED WITH SOLVENT, FED SPEC
P-D-680, OR EQUIVALENT. THEN, WIPE
DRY. APPLY A FEW DROPS OF OIL TO
THE CABLE.
STEP 3.
ACTUATE THE VALVE A FEW TIMES
WITH THE CABLE TO DISTRIBUTE OIL
ON CABLE AND ALLOW OIL TO ENTER
VALVE. WIPE OFF EXCESS OIL.
STEP 4.
INSTALL FUEL CYLINDER (FIG 3-22).
NOTE
TS5-4310-354-14/4-2
REFER TO LO5-4310-354-12, FIG 3-1,
FOR LUBRICANTS.
Figure 4-2. Quick start assembly lubrication.
NOTE
The engine starting motor, alternator, and water pump do not require lubrication
except at overhaul. The fuel injection pump is lubricated by flow of fuel oil through
the pump.
4-3
