TM 5-4310-354-14
3-25. Compressor Oil Filter.
specified in figure 3-21. (Also, refer to figure 3-5).
a. Removal. Remove the compressor oil filter as
shown in figure 3-21.
shown in figure 3-21.
TS5-4310-354-14/3-21
REMOVAL:
STEP 1.
REMOVE THE NUT THAT
STEP 2.
SOAK AND AGITATE THE ELE MENT IN A
SECURES THE FILTER COVER TO THE
CONTAINER OF SOLVENT, SUCH AS FED
THERMAL BYPASS BASE. REMOVE THE
SPEC P-D-680, TYPE II, OR EQUIVALENT,
NUT GASKET, COVER, AND COVER O-
UNTIL ELEMENT IS CLEAN.
RING GASKET FROM COVER SEAT IN
STEP 3.
DRY THE ELEMENT THOROUGHLY WITH
BASE.
COMPRESSED AIR.
STEP 2.
REMOVE THE LOCKING NUT, ELEMENT
NUT, AND WASHER FROM CENTER
INSTALLATION:
STUD. LIFT ELEMENT OFF STUD.
STEP 1.
CAREFULLY INSTALL COVER
O-RING
GASKET IN GROOVE OF BASE. INSTALL
CLEANING:
ELEMENT ON CENTER STUD.
STEP 1.
WIPE THE INSIDE OF THE COVER AND
STEP 2.
INSTALL WASHER AND ELEMENT NUT
THE COVER O-RING GASKET WITH A
ON STUD AND TIGHTEN FINGER TIGHT
CLEAN, LINT-FREE CLOTH MOISTENED
TO SECURE ELEMENT IN POSITION.
WITH SOLVENT, FED SPEC P-D-680,
INSTALL LOCKING NUT ON STUD AND
TYPE II, OR EQUIVALENT. (REFER TO
TIGHTEN AGAINST ELEMENT NUT.
STEP 3.
CAREFULLY INSTALL COVER OVER
ELEMENT AND STUD. SEAT COVER ON
O-RING GASKET IN BASE, INSTALL
CAUTION
COVER NUT GASKET AND COVER NUT.
DO NOT SCRAPE OR WIRE BRUSH
THE AIR COMPRESSOR FILTER
ELEMENT. DAMAGE OF ELEMENT
MAY RESULT.
Figure 3-21. Compressor oil filter, removal and installation.
3-34
