TM 5-4310-354-14
3-26. Quick Start Assembly.
b. Fuel Cylinder Installation. Install the quick start
a. Fuel Cylinder Removal. Remove the quick start
assembly fuel cylinder as shown in figure 3-22.
assembly fuel cylinder as shown in figure 3-22.
STEP 1.
REMOVE WINGNUTS, LOCKWASHERS,
AND CLAMP THAT SECURE FUEL
CYLINDER TO HOUSING.
WARNING
DO NOT MISHANDLE OR PUNCTURE
THE
FUEL
CYLINDER.
THE
CYLINDER CONTAINS AN ETHER
BASE
MIXTURE
THAT
IS
EXTREMELY TOXIC, VOLATILE, AND
COMBUSTIBLE.
STEP 2.
UNSCREW AND REMOVE THE CYLINDER
FROM VALVE ASSEMBLY. DISCARD THE
GASKET.
STEP 3.
SCREW THE VALVE CAP ONTO VALVE
ASSEMBLY CYLINDER OPENING UNTIL
READY TO INSTALL A NEW CYLINDER.
INSTALLATION:
STEP 1.
REMOVE VALVE CAP FROM CYLINDER
OPENING
ON
TOP
OF
VALVE
ASSEMBLY.
NOTE
TIGHTEN FUEL CYLINDER HAND
TIGHT ONLY IN VALVE ASSEMBLY.
DO NOT OVERTIGHTEN.
TS5-4310-354-14/3-22
STEP 2.
INSTALL A NEW GASKET IN VALVE
ASSEMBLY.
INSTALL A NEW FUEL
CYLINDER
IN
VALVE
ASSEMBLY.
SCREW IN UNTIL HAND TIGHT ONLY.
STEP 3.
INSTALL
CYLINDER
CLAMP
AND
SECURE WITH LOCKWASHERS
AND
WINGNUTS.
Figure 3-22. Quick start assembly cylinder, removal and installation.
3-35/(3-36 Blank)
