TM 5-4310-354-14
Section VIII. MAINTENANCE OF BATTERY BOX GROUP
4-22. General. The battery box group consists of the
4-23. Battery Box Group.
sheet metal battery box with cover, the 12-volt battery,
battery holddown, battery cables and terminals, and the
a. Removal and Disassembly.
Unhook and
battery charging slave receptacle. The battery box is
remove the battery box cover to gain access to battery
attached to the unit frame on the air end of the unit next
and group components. Remove and disassemble as
to the oil separator assembly.
shown in figure 4-10.
(Figure 4-10 Sheet 1 of 2)
(Figure 4-10 Sheet 2 of 2)
TS 5-4310-354-14/4-10(1)
A BATTERY AND BATTERY BOX
REMOVAL
STEP 4.
REMOVE CAP SCREWS AND LOCK
WASHERS FROM THE TWO CHARGING
STEP 1.
UNHOOK AND REMOVE BATTERY BOX
RECEPTACLE CABLE TERMINALS TO
COVER.
LOOSEN CLAMP NUT ON
DISCONNECT THE FOUR CABLES.
NEGATIVE AND POSITIVE BATTERY
REINSTALL THE LOCK WASHER AND
TERMINALS.
DISCONNECT
THE
CAP SCREWS IN THE CHARGING
TERMINAL CONNECTORS FROM THE
RECEPTACLE TO
PREVENT THEIR
BATTERY TERMINALS.
LOSS.
STEP 2.
REMOVE
THE
WINGNUTS,
FLAT
STEP 5.
PULL THE BATTERY NEGATIVE AND
WASHERS,
ANGLE
BOLTS,
AND
POSITIVE CABLES THROUGH BATTERY
BATTERY HOLDDOWN.
CAREFULLY
BOX. REMOVE CAP SCREW AND LOCK
LIFT BATTERY FROM BOX.
WASHER THAT ATTACH RECEPTACLE
GROUND CABLE TO COMPRESSOR
STEP 3.
REMOVE
NUTS
THAT
SECURE
TERMINAL CONNECTORS TO BATTERY
MOUNTING FLANGE AND REMOVE THE
CABLES; DISCONNECT CABLE FROM
GROUND CABLE.
REINSTALL CAP
CONNECTOR AND REINSTALL NUT ON
SCREW AND LOCK WASHER IN
CONNECTOR BOLT.
COMPRESSOR MOUNTING FLANGE TO
PREVENT THEIR LOSS.
Figure 4-10. Battery box group, removal and installation (sheet 1 of 2).
4-25
