TM 5-4310-354-14
INSTALLATION
STEP 1.
INSTALL BATTERY BOX IN POSITION ON
SKID AGAINST FRAME AND ATTACH TO
FRAME WITH FOUR CAP SCREWS AND
LOCKNUTS.
STEP 2
INSTALL CHARGING RECEPTACLE
GASKET IN POSITION ON OUTSIDE OF
HOUSING END PANEL.
INSTALL
CHARGING
RECEPTACLE
WITH
POSITIVE TERMINAL ON TOP. INSTALL
INSULATOR ON INSIDE OF END PANEL
AND SECURE THE ASSEMBLY TO
PANEL WITH FOUR SCREWS, FLAT
WASHERS, AND LOCKNUTS WITH ONE
OF THE SCREWS ATTACHING THE CAP
CHAIN.
STEP 3.
REMOVE NUT AND LOCK WASHER
FROM STARTER CABLE TERMINAL ON
STARTER
INSTALL
STARTER CABLE ON TERMINAL AND
REINSTALL LOCK WASHER AND NUT.
STEP 4.
REMOVE CAP SCREW AND LOCK
WASHER
FROM
MOUNTING
FLANGE,
INSTALL
CHARGING
RECEPTACLE GROUND
CABLE AND REINSTALL LOCK WASHER
AND CAP SCREW. RUN THE BATTERY
POSITIVE AND NEGATIVE CABLES
B CHARGING RECEPTACLE
THROUGH BATTERY BOX, REMOVE CAP
SCREWS AND LOCK WASHERS FROM
CHARGING RECEPTACLE TERMINALS;
CONNECT THE FOUR CABLES TO
CHARGING RECEPTACLE WITH LOCK
WASHERS AND CAP SCREWS JUST
REMOVED.
(REFER TO WIRING
DIAGRAM, FIG 1-3.)
NOTE
UNIT
ELECTRICAL
SYSTEM
IS
NEGATIVE GROUND.
TS 5-4310-354-14/4-10(2)
STEP 5.
INSTALL
BATTERY
CABLE
CONNECTORS TO NEGATIVE AND
POSITIVE CABLES.
MAKE CERTAIN
C STARTING MOTOR
THAT
THE
CONNECTORS
ARE
INSTALLED
ON
CORRECT
CABLE
STEP 6.
REMOVE NUT AND LOCK WASHER
(NEGATIVE CONNECTOR ON NEGATIVE
THAT ATTACH STARTER CABLE TO
CABLE).
STARTER SOLENOID.
REMOVE THE
STEP 6.
CAREFULLY INSTALL BATTERY IN BOX.
STARTER CABLE AND REINSTALL
POSITION HOLDDOWN OVER BATTERY
LOCK WASHER AND NUT ON SOLENOID
AND SECURE WITH ANGLE BOLTS,
TERMINAL TO PREVENT THEIR LOSS.
FLAT WASHERS, AND WINGNUTS.
STEP 7.
REMOVE FOUR LOCK NUTS, FLAT
STEP 7.
CONNECT
THE
BATTERY
CABLE
WASHERS,
AND
SCREWS
THAT
CONNECTORS
TO
THE
BATTERY
ATTACH THE CHARGING RECEPTACLE
TERMINALS AND TIGHTEN SECURELY.
TO HOUSING END PANEL.
REMOVE
MAKE CERTAIN CONNECTIONS ARE
THE RECEPTACLE WITH CAP AND
CORRECT.
CHAIN, GASKET, AND INSULATOR.
STEP 8.
REFER TO FIG 3-10 AND SERVICE THE
STEP 8.
REMOVE FOUR LOCKNUTS AND CAP
BATTERY AS NECESSARY.
INSTALL
SCREWS THAT ATTACH BATTERY BOX
THE BATTERY BOX COVER.
TO FRAME AND REMOVE THE BATTERY
BOX.
Figure 4-10. Battery box group, removal and installation (sheet 2 of 2)
4-26
