TM 5-4310-354-14
TS 5-4310-354-14/4-12
REMOVAL
INSTALLATION
STEP 1.
REMOVE THE RADIATOR FILLER CAP.
STEP 1.
INSTALL THE TWO AIR CLEANER CAPS.
STEP 2.
UNSCREW AND REMOVE THE MUFFLER
STEP 2.
INSTALL THE MUFFLER IN EXHAUS T
AT THE EXHAUST PIPING COUPLING.
PIPING COUPLING.
STEP 3.
REMOVE THE TWO AIR CLEANER CAPS.
STEP 3.
INSTALL THE RADIATOR FILLER CAP.
Figure 4-12. Exterior components on compressor enclosure, removal and installation.
REMOVAL
STEP 1.
REFER TO FIG 3-14 AND REMOVE FUEL
CYLINDER. INSTALL VALVE CAP TO
PREVENT DIRT FROM ENTERING VALVE
UNTIL FUEL CYLINDER IS AGAIN
INSTALLED.
STEP 2.
REMOVE CYLINDER CLAMP STUDS
FROM END PANEL.
DISCONNECT
QUICK-START CABLE FROM VALVE
LEVER
AND
CABLE
CLAMP.
DISCONNECT FUEL LINE FROM VALVE.
STEP 3.
REMOVE
LOCK
NUTS
AND
CAP
SCREWS THAT SECURE VALVE TO END
PANEL AND REMOVE THE VALVE
ASSEMBLY.
INSTALLATION
STEP 1.
INSTALL VALVE ASSEMBLY ON END
PANEL AND SECURE WITH CAP
SCREWS AND LOCK NUTS.
STEP 2.
CONNECT FUEL LINE TO VALVE.
CONNECT
QUICK-START
CABLE
THROUGH CABLE CLAMP ON VALVE
AND ATTACH TO VALVE LEVER.
TIGHTEN CLAMP.
INSTALL FUEL
CYLINDER CLAMP STUDS TO END
PANEL.
STEP 3.
REMOVE CAP FROM VALVE AND
INSTALL FUEL CYLINDER.
TIGHTEN
FUEL CYLINDER HAND TIGHT ONLY (FIG
TS 5-4310-354-14/4-13
Figure 4-13. Quick start assembly, removal and installation
4-31
