TM 5-4310-356-14
Section VI. MAINTENANCE OF THE ELECTRIC MOTOR AND COMPRESSOR
Figure 4-4. Electric motor and compressor assembly, removal and installation.
4-12. General.
electric motor as follows:
The electric motor can be removed from the air
(1) Place electric motor in position and
receiver tank as a unit after removal of the V-belt guard,
loosely install mounting bolts.
belts, and electrical leads have been disconnected. The
air compressor assembly can be removed as a unit after
the V-belt guard, belts and aftercooler tube are
(2) Install and adjust V-belt tension as
removed.
described in paragraph 4-14 below.
(3) Install V-belt guard and tighten attaching
4-13. Electric Motor.
hardware securely.
electric motor as follows:
(4) Connect electrical leads.
CAUTION
4-14. Compressor Assembly
Make sure main power source is disconnected.
compressor assembly as follows:
(1) Remove attaching hardware and remove
(1) Remove attaching hardware and remove
V-belt guard.
V-belt guard.
(2) Tag and disconnect electrical leads.
(2) Disconnect and remove aftercooler tube.
(3) Remove motor mounting bolts.
(3) Remove compressor mounting bolts.
(4) Remove V-belts from motor pulley.
(4) Remove
V-belts
from
compressor
(5) Remove electric motor assembly.
flywheel and remove compressor assembly.
4-6
