TM 5-4310-356-14
Figure 4-5. Compressor components and V belt drive.
4-17. Air Intake Muffler
4-16. Release Valve Assembly Replacement
a. Removal and Disassembly. Refer to figure 4-
intake muffler as follows: Loosen set screw securing air
6 and remove and disassemble release valve assembly
intake muffler to intake manifold and remove intake
as follows: Remove release valve body (1, fig. 4-6),
muffler.
spring (2), ball (3), and plunger (4).
b. Cleaning, Inspection and Repair.
c. Installation. Install intake muffler on intake
(1) Clean all parts and wipe dry with a lint
manifold as shown in figure 4-5 and secure by tightening
free cloth.
setscrew.
(2) Check the spring (2) for disfiguration, or
4-18. Air Receiver Repair
loss of tension. Replace a defective spring.
components by disassembling in numerical sequence as
(3) Check ball (3), body (1), and plunger (4)
shown.
for excessive wear, burred threads and general
condition. Replace damaged or defective parts as
necessary.
b. The check valve (9), can be disassembled for
cleaning. Refer to figure 4-8 and disassemble following
the numerical sequence. Reassemble in reverse order
(4) Replace deteriorated gaskets.
of the disassembly.
c. Replace defective or damaged components and
reassemble and install in reverse order of their removal.
procedures.
4-8
