TM 5-4310-356-14
Section II. REPAIR PARTS, SPECIAL TOOLS, AND EQUIPMENT
4-6. Special Tools and Equipment.
4-7. Maintenance Repair Parts.
There are no special tools or equipment required
Repair parts and equipment are listed and
to perform maintenance on the air compressor.
illustrated in TM 5-4310-356-24P, Organizational, Direct
Support and General Support Maintenance Repair Parts
and Special tools Lists.
Section III. LUBRICATION INSTRUCTIONS
Refer to Paragraph 3-2 for lubrication instruction for this air compressor.
Section IV. PREVENTIVE MAINTENANCE CHECKS AND SERVICES
Because all required inspections must be made
daily, or more frequently, organizational maintenance
4-9. Preventive Maintenance Checks and Services.
personnel will refer to table 4-1, for procedures to be
followed during their periodic inspection.
Refer to table 4-1 for a listing of the Preventive
Maintenance checks and Services which are allocated
4-8. General.
to organizational maintenance.
This section lists the preventive maintenance
NOTE
checks and services which shall be performed on a
Use Tables 3-1 and 3-2 for
monthly or quarterly basis by organizational
preventive maintenance checks
maintenance personnel. It includes and expands upon
and services, then return to this
the preventive maintenance services performed by
Table for expansion of checks
operator/crew maintenance and includes additional
and services.
services which are allocated to organizational
maintenance.
Table 4-1. Organizational Preventive Maintenance Checks and Services.
Item
Item
Equipment
No.
Interval
To be
Will be Reported
Q
Inspected
Procedures
not Ready (Red) if:
1
Compressor frame oil
Refer to LO-4310-356-12 for
type, then drain and change
oil.
2
Capscrews, screws,
Check for tightness.
and bolts
Section V. TROUBLESHOOTING
actions. If a malfunction is not listed or is not corrected
4-10. Scope.
by listed corrective actions, you should notify higher
a. This section contains troubleshooting or
level maintenance.
malfunction information and tests for locating and
correcting most of the troubles which may develop in the
c. Only those functions which are solely within the
air compressor. Each malfunction or trouble symptom
scope of organizational maintenance are listed. For
for an individual component, unit, or system is followed
troubleshooting procedures which are within the scope
by a list of tests or inspections necessary for you to
of operator/crew maintenance, refer to paragraph 3-3.
determine probable causes and suggested corrective
4-11. Organizational Maintenance Troubleshooting
actions for you to remedy the malfunction.
Chart.
b. This manual cannot list all possible malfunctions
Refer to table 4-2 for troubleshooting which is
that may occur or all tests or inspections, and corrective
allocated organizational maintenance levels.
4-4
