TM 5-4310-356-14
1. Set screw, socket
12.
Bearing, rear
2. Pulley
13.
rotor/shaft assy.
3. Key
14.
Fan
4. Bolt, thru (4)
15.
Frame/stator assy
5. Endbell, rear
16.
Box, conduit
6. Spring, wavy
17.
Cover, conduit box
7. Endbell, front
18.
Nut (4)
8. Baffle
19.
Lockwasher (4)
9. Shim
20.
Flat washer (4)
10. Bearing, front
21.
Capscrew (4)
11. Bushing
Figure 5-10. Electric motor assembly.
5-7. Magnetic Starter.
b. Cleaning, Inspection and Repair.
a. Removal and Disassembly.
stator in an approved cleaning solvent and wipe dry with
a lint free cloth.
magnetic starter as shown.
(2) Use compressed air to clean dust and dirt
off rotor, bearings, and stator, then wipe with a cloth
cap (12), contact kit (13), contact carrier (14), operating
dampened in an approved cleaning solvent.
coil (15), coil heater (16), overload relay (17), and
interlock assembly (18).
excessive wear, and rough or scored surfaces. Replace
b. Cleaning, Inspection and Repair.
defective bearings. Replace a defective rotor shaft.
(1) Use compressed air and remove all dust
c. Reassembly and Installation.
or dirt from magnetic starter components.
assembly (13) into stator and frame 815).
coil, relay overload, contact carrier and interlock
assembly. Replace defective parts.
(2) Install fan (14), wavy spring (6), opposite
shaft end bearing (10), shaft end bearing (12), opposite
end, end bell (7), shaft end, end bell (5), and secure with
action. Replace a defective on-off switch.
the four bolts (4).
electric motor assembly.
5-20
