TM 5-4310-368-14
(3)
Pull up and out on rim of flywheel. Rap end of crankshaft with babbit mallet while pulling on flywheel.
Repeat until flywheel is free.
(4)
Remove flywheel from engine.
b. Cleaning. Clean flywheel in cleaning solvent. Dry thoroughly.
c.
Inspection
(1)
Inspect flywheel for damaged or missing blower fins. Replace defective flywheel.
(2)
Inspect starter ring gear.
d. Installation
(1)
Verify installation of woodruff key in crankshaft.
(2)
Position flywheel over end of crankshaft. Align keyway in flywheel bore with woodruff key. Install flywheel.
(3)
Secure flywheel with nut and washer.
(4)
Install starting crank pin.
5-16.
TIMING COVER
This task covers:
a. Inspection
INITIAL SETUP
Applicable Configurations
All
a. Inspection. Inspect timing cover for evidence of damage or leaks.
5-32
