TM 5-4310-368-14
(8)
Position new gasket onto governor.
(9)
Position governor onto engine. Align bolt holes in governor body with bolt holes in engine. Attach
governor to engine with four screws and four washers. Secure screws. Connect and secure oil line to
governor body fitting.
(10) Connect tension spring to top spring hole in governor arm.
Attach throttle link rod to hole at top of
governor arm.
(11) Start engine.
(12) Check for oil leaks.
(13) Check for proper governor operation.
(14) Stop engine.
5-15.
This task covers:
a. Removal
c.
Inspection
b. Cleaning
d. Installation
INITIAL SETUP
Applicable Configurations
All
Equipment Condition
Paragraph
Condition Description
Enclosure Corner Post Removed
Flywheel Screen Removed
General Safety Precautions
WARNING
Dry cleaning solvent, P-D-680, used to clean parts is potentially
dangerous to personnel and property. Avoid repeated and prolonged
skin contact. Do not use near open flame or excessive heat. Flash
point of solvent is 100 (38 ) - 138 (59 ).
F
C
F
C
a. Removal
(1)
Drive starting crank pin out of crankshaft.
(2)
Remove flywheel nut and washer.
5-30
