TM 5-4310-368-14
c.
Cleaning. Clean all parts in cleaning solvent. Dry thoroughly.
d. Inspection
(1) Inspect all threaded parts and tapped holes for thread damage. Replace defective parts.
(2) Inspect O-rings and backup rings for cuts, wear and damage. Replace defective parts.
(3) Inspect filter element for cracks, holes or chips. Replace defective element.
e. Reassembly
(1) Position filter element, retainer plate and top deflector over tube in top plug. Assemble and secure parts with
nozzle.
(2) Position deflector plate over nozzle.
(3) Align screw hole in plate with tapped hole in nozzle. Secure plate to nozzle with one screw.
(4) Assemble O-ring and lockup ring to bottom plug.
(5) Install and secure bottom plug into separator body. Remove two 3/8-16 x 2" socket head screws.
(6) Apply teflon tape to pipe threads of bottom fitting.
(7) Install and secure bottom fitting into bottom plug.
NOTE
Make sure bottom fitting is properly oriented.
(8) Assemble O-ring and lockup ring to top plug.
(9) Install and secure top plug into separator body. Remove two 3/8-16 x 2" socket head screws.
(10)
Assemble and secure top fittings into separator top plug.
NOTE
Fitting with check valve is to be installed in "OUT" post.
e. Installation
(1) Position separator assembly against frame brackets.
(2) Loose assemble separator assembly to frame brackets with two straps, four bolts and four nuts.
(3) Hold separator in proper position and secure straps, bolts and nuts.
5-42
