TM 5-4310-369-14
Table 3-2. Troubleshooting - Continued
Malfunction
Test or Inspection
Corrective Action
c. Lift out air filter elements (3) and check for dirt. Service the air filter elements.
Drycleaning solvent, P-D-680, used to clean parts is potentially dangerous to personnel and property. Avoid
repeated and prolonged skin contact by wearing rubber or solvent impermeable gloves when handling the solvent
or material wet with drycleaning solvent. Wash hands immediately after exposure with soap and water and use a
lanolin based skin cream to prevent skin drying. Do not use near open flame or excessive heat. Flash point of
solvent is 100F (38C). Ensure that ventilation adequate to reduce solvent vapor concentrations below acceptable
threshold limit values is provided.
When using compressed air for blowing, air hose pressure must not exceed 30 psi, and individuals must wear eye
protective equipment.
(1) Clean the air filter with cleaning solvent, P-D-680, and dry thoroughly.
(2) Clean filter by washing with cleaning solvent, P-D-680, and blowing out with air.
(3) Replace defective filter elements.
(4) Reinstall filter elements.
(5) Reinstall air filter rain caps to cylinder heads with bolts.
Step 2. Check for leaks from air receiver tank fittings.
EXCESSIVE COMPRESSOR OIL CONSUMPTION.
2.
Replace compressor crankcase oil.
a. Position suitable container beneath compressor crankcase drain pipe and remove cap (1) from pipe.
