TM 5-4310-375-14
Perform all before operation preventive maintenance checks and
Initial adjustments, daily checks, and self test.
2-6.
services (PMCS) shown in table 2-1 and the following:
WARNING
Electricity is dangerous. Before performing any adjustments or maintenance,
be sure the electrical power is turned off. Never depend on the ON-OFF switch,
Turn power off at the source.
NOTE
Refer to paragraph 3-2 for lubrication instructions.
Turn electrical power source OFF at the source to prevent electrical shock while making initial main power
a.
connections. Make certain ON-OFF switch (4, figure 2-1) is in OFF position.
b. Open cover of motor control box (2, figure 2-1) and connect main power source leads to motor starter
terminals as shown on wiring diagram, figure 1-2. Close cover of motor control box (2, figure 2-1). Press reset
button (3) to make certain relay is not tripped.
c.
The unit was tested by the manufacturer prior to shipment; therefore, no adjustment of pressure switch (1, figure
2-1) is necessary.
e . Turn main power source ON.
2-9
