TM 5-4310-375-14
2-13. Operation in salt air, sea spray, or high humidity. Protect the unit with a shelter keeping enough open area for
good ventilation.
a. Wipe unit dry at frequent intervals. Pay particular attention to motor and motor control box. If unit becomes
covered with salt from salt spray, wash unit with fresh water. Take care not to damage electrical system with water.
b. Lubricate the compressor in accordance with paragraph 3-2. Make certain surfaces around lubrication points are
clean and dry.
c. If exposed metal surfaces become rusty, remove rust and coat the area with suitable rustproof material or grease
until unit can be thoroughly cleaned and painted.
d. Open air receiver drain cock frequently to blow out accumulated condensate.
2-14. Operation in dusty or sandy areas. Protect the unit with a suitable shelter but provide adequate ventilation to
prevent overheating.
b. Lubricate compressor in accordance with paragraph 3-2. Make certain areas around lubrication points are clean
before lubricating. Wipe areas clean of any spilled lubricants after lubricating.
c. Keep the motor, motor control box, air compressor cooling fins, and air receiver tank free of accumulated
dirt or sand.
d. Keep the unit covered with a tarpaulin when not in use.
2-14
