TM 5-4310-376-14
4-17(A) UNLOADER ASSEMBLY (Cont.)
LOCATION/ITEM
ACTION
REMARKS
c.
The differential (difference
Adjust screw (3) so that
between cut-in and cut-out
pressure) is obtained by
compression at 175 PSI
adjusting screw (3). Turning
clockwise will widen the
starts pumping air into
differential and counter-
receiver.)
clockwise will narrow the
differential.
d.
Repeat items 1 & 2 until desired
Cut-off pressure should
be 195 PSI and cut-in
settings are obtained. It is
pressure should be 175
not advisable to have a
PSI.
differential of less than
10% of the maximum cut-out
pressure.
Hold nut (1) while tighten-
e.
After adjustments are made,
tighten jam nuts (2) & (4)
ing (2) and nut (3) while
tightening (4) to have the
correct adjustment.
NOTE
If you cannot get proper adjustment (cut-off pressure = 195 PSI and cut-in
4-34.1/(4-34.2
blank)
Change 1
*U.S. GOVERNMENT PRINTING OFFICE: 1987754-030/60054