TM 5-4310-378-14
a. Inspection.
(1) Inspect for missing or damaged hardware.
(2) Inspect compressor flywheel for damage
b. Replacement
Replace defective compressor flywheel as follows:
(1) Removal
(a) Remove flywheel thrust bolt and washer.
(b) Using gear puller, remove flywheel.
D r y Cleaning Solvent
(Stoddard Solvent)
P-D-680
Combustible - do not use near open flames, near welding areas,
q
or on hot surfaces.
Prolonged or repeated contact of skin with liquid can cause
q
d e r m a t i t i s . Repeated inhalation of vapor can irritate nose and
throat and can cause dizziness.
If any liquid contacts skin or eyes, immediately flush affected
q
a r e a thoroughly with water. Remove solvent-saturated
clothing. If vapors cause dizziness, go to fresh air.
When handling liquid or when applying it in an air-exhausted,
q
partially covered tank, wear approved gloves.
When handling liquid or when applying it at an unexhausted,
q
uncovered tank or workbench, wear approved respirator,
g o g g l e s , and gloves.
Installation
(2)
(a) Use brush, rag, and solvent as necessary to clean compressor crankcase before
installing flywheel.
(b) Install flywheel and secure with thrust washer and thrust bolt.
3-27
