TM 5-4310-378-14
b. Replacement.
Replace defective interstage relief valve as follows:
( 1 ) Removal
(a) Using 5/8-in. wrench, remove interstage relief valve.
(2) Installation
(a) Install interstage relief valve.
This task covers:
Replacement
Tools: Pipe wrench, adjustable jaw, one to two inches capacity.
Materials: Brush Cleaning (Appendix E, item 1)
Rag, Wiping (Appendix E, item 3)
Solvent, Dry Cleaning (Appendix E, item 2)
Compressor Air Cleaner Assembly
Equipment Condition: Ignition switch pushed in (Table 2-1, 8).
Replacement. Replace defective air cleaner assembly as follows:
Removal.
a.
WARNING
I
I
Dry Cleaning Solvent
(Stoddard Solvent)
P-D-680
Combustible- do not use near open flames, near welding areas, or on hot sur-
faces.
Prolonged or repeated contact of skin with liquid can cause dermatitis. Re-
peated inhalation of vapor can irritate nose and throat and can cause dizzi-
ness.
If any liquid contacts skin or eyes, immediately flush affected area thoroughly
with water. Remove solvent-saturated clothing. If vapors cause dizziness, go
to fresh air.
When handling liquid or when applying it in an air-exhausted, partially cov-
ered tank, wear approved gloves.
When handling liquid or when applying it at an unexhausted, uncovered tank
or workbench, wear approved respirator, goggles, and gloves.
(1) Clean compressor head, as necessary, using a clean, soft cloth (Appendix E, item 3) or a medium bristle
brush (Appendix E, item 1) and cleaning solvent (Appendix E, item 2).
(2) Using pipe wrench, carefully remove air cleaner assembly. Grip body (l).
