TM 5-4310-378-14
3-45. WHEELS
This task covers:
a.
Inspection
b.
Replacement
Tools:
S l i p Joint Pliers
Materials:
B r u s h , Cleaning (Appendix E, item 1)
Rag, Wiping (Appendix E, item 3)
S o l v e n t , Dry cleaning (Appendix E, item 2)
G r e a s e (Appendix E, item 4)
W h e e l Assembly
Cotter Pin
F l a t Washer
I g n i t i o n switch pushed in (Table 2-1, 8).
Equipment Condition:
a. I n s p e c t i o n .
WARNING
Dry Cleaning Solvent
(Stoddard Solvent)
P-D-680
C o m b u s t i b l e - do not use near open flames, near welding areas,
o r on hot surfaces.
P r o l o n g e d or repeated contact of skin with liquid can cause
d e r m a t i t i s . Repeated inhalation of vapor can irritate nose and
t h r o a t and can cause dizziness.
I f any liquid contacts skin or eyes, immediately flush affected
a r e a thoroughly with water. Remove solvent-saturated
c l o t h i n g . If vapors cause dizziness, go to fresh air.
W h e n handling liquid or when applying it in an air-exhausted,
partially covered tank, wear approved gloves.
W h e n handling liquid or when applying it at an unexhausted,
uncovered tank or workbench, wear approved respirator,
g o g g l e s , and gloves.
U s e brush, rag, and solvent as necessary to clean wheels and tires.
(2) Inspect for bent rims or other damage.
(3) Inspect for corrosion.
( 4 ) Inspect for damage or missing grease fitting (1) and bearings (2).
3-66
