TM 5-4310-378-14
4-8. ENGINE GOVERNOR AND CONTROL ASSEMBLY
This task covers;
a . Adjustment
b . Replacement
Tools:
Materials:
10-mm Wrench
Governor Lever
Revolution Counter
Clamp Screw and Nut
Governor Spring and Rod Set
Equipment Condition: Engine removed from handtruck (para 3-21)
WARNING
Keep fingers and hand away from rotating pulley to pre-
vent injury to personnel.
Adjustment.
a.
(1) Loosen locknut (1) on adjusting screw (2).
(2) Operate engine without load and push control lever (3) in a counterclockwise direction so that
adjusting screw (2) is against stop lug (4).
(3) Place a revolution counter against the end of the crankshaft and rotate the adjusting screw (2) to
obtain 2850 RPM. Righten locknut(1).
4-16.1/(4-16.2 blank)
Change 3
