TM 5-4310-379-14
5-26. Clutch Assembly (Cont).
(10)
Inspect three clutch discs (21) and replace if worn, cracked, excessively scored, or missing teeth. Replace
any clutch disc that is less than .3125 in. (.7947 cm) thick.
(11)
Inspect face of clutch body (20) and replace clutch body (20) if face is cracked, worn, warped, or clutch
body (20) is otherwise damaged.
(12)
Inspect pressure plate (18) and replace if worn, cracked, warped, or otherwise damaged.
(13)
Inspect the adjusting ring (17) and replace if threads are stripped or ring (17) is otherwise damaged.
(14)
Inspect clutch release sleeve (2) and collar (3) mating surfaces and replace if either piece is cracked,
shows excessive wear, or are otherwise damaged.
(15)
Inspect yoke (22) and replace if cracked, bent, worn, or otherwisedamaged.
(16)
Inspect grease line (23) and replace if line is cracked or fittings are stripped or otherwise damaged.
(17)
Inspect drive ring (24) and replace if cracked, teeth are worn, chipped, missing or ring (24) is otherwise
damaged.
(18)
Inspect all other items and replace all items that are worn or otherwise damaged.
(19)
Check springs (19). Spring pressure should be 15 to 20 lbs (33-44 kg) when spring is compressed to
1.8125 in. (2.072 cm). Replace a spring which does not meet the specification.
(20)
Install three springs (19) and pressure plate (18) on clutch body (20).
(21)
Install adjusting ring (17) in pressure plate (18) fully.
(22)
Install lock (16) and secure with screw (14) and lockwasher (15).
NOTE
Install pins with head of pin in direction of rotation of clutch.
(23)
Install three levers (13) and secure with three pins (12) and retaining rings (11).
(24)
Install six links (10) and secure with three pins (9) and retaining rings (8).
(25)
Install release sleeve (2) and position six links (10) and secure with three pins (7) and retaining rings (6).
(26)
Lubricate two halves of release sleeve collar (3).
(27)
Install release sleeve collar (3) and secure with two screws (4) and nuts (5).
5-112