TM 5-4310-379-14
5-27. Compressor Intercooler.
This task covers:
Replace
INITIAL SETUP:
Tools
Materials/Parts (Cont)
General Mechanic's Tool Kit
(NSN 5180-00-177-7033)
Bands, Rubber (Item 5, Appendix D)
Puller, Mechanical (NSN 5120-00-313-9496)
Bags, Plastic (Item 4, Appendix D)
Torque Wrench (NSN 5120-0-554-7292)
Detergent, Nonionic (Item 10, Appendix D)
Materials/Parts
Equipment Condition
Intercooler
Air compressor assembly removed (para. 4-24).
Gasket, Intercooler
Shroud removed (para. 4-29).
Tape (Item 24, Appendix D)
Replace. (figure 5-34)
(1)
Remove two nuts (1), washers (2), and pulley hub clamp bolts (3).
(2)
Using suitable puller, remove pulley (4) and pulley key (5), from crankshaft (6).
WARNING
Cleanliness is imperative in maintaining and handling diving air system components. All tools and
parts must be kept free of oil, grease, rust, or other contamination in accordance with accepted
army diving cleaning procedures. Foreign substances within an assembly could result in
equipment failure and possible injury or death to personnel.
Ensure that all air lines and components removed or openings into the air system that provides
breathing air are covered with a plastic bag and secured with a rubber band or taped shut. Small
components should be stored in a plastic bag and sealed. Failure to do so will cause air system to
become contaminated and could result in injury or death to the diver.
(3)
Remove ten screws (7), lockwashers (8) and four bracket (9) securing intercooler (10) to head assemblies
(11).
(4)
Remove two screws (12), lockwashers (13), washers (14), and spacers (15) securing intercooler sleeve
assembly (16).
(5)
Remove screw (17) and washer (18) from each cylinder head securing intercooler.
(6)
Remove intercooler (10) and two gaskets (19).
Change 1 5-114
