TM-5-4310-389-14
Figure 4-69. Clutch
2.
Attach a suitable lifting device to the power take-off.
3.
Remove the hex head cap screws that secure the power take-off housing to the flywheel housing.
CAUTION
Caution should be exercised when removing the power take-off from the engine so that the facings
and pilot bearing are not damaged.
4.
Support the power take-off on blocks with output end of the shaft down.
5.
Remove two screws (1), nameplate (2), and gasket (3) from the power take-off housing (13).
6.
Use 3/8-16 x 1/4-inch bolts in the PTO mounting flange threaded holes if necessary to separate the PTO from
the flywheel housing.
4-99
