FIGURE 5-25. ASSEMBLE PUSHRODS

TM-5-4310-393-14 Air Compressor Diesel Engine Driven 20 CFM 3200 PSI Model KA7-DA Manual
Page Navigation
117

TM 5-4310-393-14 2. Installing the Pushrod Assemblies. a. Install new preformed packing (Figure 5-25, Item 4), shims (5), and new pressure springs (6), on protection tubes (3). b. Install protection tubes (3). c. Install complete pushrod (2) closest to injection pump side of engine. d. Install pushrod (1). 3. Installing the Cylinder Head. a. Install two hollow dowel pins (Figure 5-26, Item 3) in bottom of cylinder head. b. Install NEW gasket (2) on bottom of cylinder head (1). c. Place cylinder head over studs and onto cylinder. d. Install rocker shaft (Figure 5-27, Item 3) with rockers, two air shields, and lifting eye. Install clamp (4). FIGURE 5-25. ASSEMBLE PUSHRODS e. Install four nuts (1) on the four studs (2). Tighten nuts equally and crosswise to a torque of 26 lb -ft (35 Nm). 4. Completion of Reassembly. a. Install new gasket (Figure 5-28, Item 6) on cylinder head. b. Install cylinder head cover (5) on gasket (6). c. Install two spring washers (4) and nuts (3). Tighten securely. d. Install pipe clip (2), washers (7), and screw (1). e. Install cowling (Figure 5-29, Item 3) on engine. f. Install screw (1) and hex nut (2). g. Install screws (4) and washers (5). 5-22

Privacy Statement
Press Release
Contact