TM 5-4310-451-14
4-62. FRONT AXLE REPLACEMENT (Con’t).
b. INSTALLATION
1.
Install hubs and wheel bearings (see paragraph 4-68).
2.
Install steering knuckles (see paragraph 4-70).
3.
Install tie-rods (see paragraph 4-72).
4.
Install drawbar (see paragraph 4-73).
5.
Remove axle (4) from jackstands.
NOTE
Ensure that pin on spring aligns with hole in axle.
6.
Position axle (4) under air compressor unit and raise Into position.
7.
Install two brackets (3) and four U-bolts (1) on axle (4) with eight nuts (2).
8.
Remove lifting device from under axle (4).
FOLLOW-ON TASKS:
• Remove air compressor unit frame from jackstands.
4-139
