TM 5-4310-451-14
4-66. BRAKESHOE REPLACEMENT.
This Task Covers:
a.
Removal
c.
Installation
b.
Cleaning and Inspection
Initial Setup:
Equipment Conditions:
Tools/Test Equipment:
• Hub and brakedrum removed (see paragraph 4-69).
• General mechanic's tool kit
General Safety Instructions:
• Common no. 1 shop set
• DO NOT use a dry brush or compressed air to clean brake components.
a. REMOVAL
WARNING
DO NOT handle brakeshoes, brakedrums, or other brake components unless area has been
properly cleaned. There may be asbestos dust on these components which can be dangerous If
you touch It or breathe It. Wear an approved filter mask and gloves. Never use compressed air or
a dry brush to clean brake components. Dust may be removed using an Industrial-type vacuum
cleaner. Clean dust or mud away from brake components with water and a wet, soft brush or
cloth. Failure to follow this warning may result In serious Illness or death to personnel.
1. Remove two nuts (1), screws (4), spacers (3), and upper backing plate (2) from mounting plate (5) and axle (6).
TA704808
4-148
