TM 5-4310-451-14
4-71. STEERING ARM REPLACEMENT.
This Task Covers:
a
Removal
c
Installation
b.
Cleaning and Inspection
Initial Setup:
Equipment Conditions:
Materials/Parts:
•
Drawbar removed (see paragraph 4-73).
•
Dry cleaning solvent (Item 38, Appendix E)
•
Two cotter pins
Tools/Test Equipment:
•
Two spring pins
•
General mechanic's tool kit
•
Common no. 1 shop set
General Safety Instructions:
•
Dry cleaning solvent is flammable and must not be used near open flame. Use only in a well-ventilated area.
a.
REMOVAL
1.
Remove two cotter pins (2), slotted nuts (1), and tie-rod ends (3) from steering arm (4). Discard cotter pins.
2.
Remove two spring pins (7) from pin (6). Discard spring pins.
3.
Remove pin (6) and steering arm (4) from axle bracket (5).
TA704828
4-172
