TM 5-4310-451-14
5-17. ENGINE BLOCK REPAIR (Con’t).
c. ASSEMBLY
1.
Install new gasket (15) and plate (14) on engine block (2) using four washers (13) and screws (12).
2.
If removed, Install six cylinder head studs (3).
3.
If any cylinder head studs (3) were replaced, perform steps 4 and 5. Otherwise, perform step 6.
4.
Torque cylinder head stud (3) to 75 lb.-ft. (102 Nom) minimum.
5.
Check that replaced cylinder head stud (3) measures 4.375 in. (111.125 mm) above engine block (2).
6.
Install three cup plugs (5) in right and left side of engine block (2).
7.
If removed, install two dowel pins (9) in front and two dowel pins (9) in rear of engine block (2). Ensure that dowel
pins extend 0.88 in. (22.35 mm) from ends of engine block.
8.
Install draincock (10) and two draincocks (6).
9.
Apply sealing compound to threads of all pipe plugs and install five pipe plugs (8), six pipe plugs (7), four pipe
plugs (4), six pipe plugs (11), and four pipe plugs (1) in engine block (2).
TA704910
5-28
