TM 5-4310-451-14
5-52. INJECTOR RACK CONTROL LEVER ADJUSTMENT.
This Task Covers: Adjustment
Initial Setup:
Equipment Conditions:
Materials/Parts:
• Exhaust valve clearance adjusted (see paragraph
• Two cotter pins
5-49).
•· Fuel injector timing adjusted (see paragraph 5-50).
Tools/Test EquIpment
•· Governor gap adjusted (see paragraph 5-51).
• General mechanic's tool kit
•· Rocker arm covers removed (see paragraph 4-29).
• Field automotive shop set
ADJUSTMENT
NOTE
Adjust Injector rack control lever at left-front of engine first, then adjust Injector rack control lever at right-
front of engine.
1. Remove cotter pin (5) and clevis pin (3) to disconnect fuel rod (4) from right Injector control tube lever (6). Discard
cotter pin.
2. Loosen three locknuts (1) and screws (2) on right injector control tube (7).
5-169
