TM 5-4310-451-14
5-59. FUEL INJECTOR CONTROL TUBE MAINTENANCE (Con’t).l
12.
Remove pin (20) and clevis (6) from control tube
(4). Discard pin.
13.
Remove spacer (18) and bracket (19) from
control tube (4).
RIGHT BANK CONTROL TUBE
c.
CLEANING INSPECTION
WARNING
Dry cleaning solvent, P-D-680, Is toxic and flammable. Always wear protective goggles and gloves, and
use only In a well-ventilated area. Avoid contact with skin, eyes, and clothes, and DO NOT breathe
vapors. DO NOT use near open flame or excessive heat. The solvent's flash point Is 100°F-138°F
(380C-59°C). If you become dizzy while using cleaning solvent, immediately get fresh air and medical
help. If solvent contacts eyes, Immediately wash your eyes and get medical aid.
Compressed air used for cleaning or drying purposes, or for clearing restrictions, should never exceed 30
psl (207 kPa). Wear protective clothing (goggles/shield, gloves, etc.) and use caution to avoid Injury to
personnel.
1.
Clean all parts with dry cleaning solvent and dry with compressed air.
2.
Inspect parts for damage. Replace damaged parts.
d.
ASSEMBLY
NOTE
Steps 1 through 8 are for assembly of right bank Injector control tube. Steps 9 through 14 are for
assembly of left bank Injector control tube.
1.
Install bracket (19) and spacer (18) on control tube (4).
2.
Install clevis (6) on control tube (4) with new pin (20).
TA705068
5-196
